| Search results - "d" |
footie_anyone.jpgFootie, anyone?10 viewsL Osbaldiston plane iron, "Hydra" brand, with a leg kicking a football?dlarue
|
|
chair1.jpgfinials, finally28 viewsMy dubious attempt at the finials.
I may re-turn these before final assembly.
dlarue
|
|
chair2.jpgpile of turnings28 viewshere is the pile of turnings from the pole lathe. Still need to finish a bunch of them, they are just rough turned at this point.dlarue
|
|
2018_01_27_3110_GClausSS.jpgGalootaclaus 2017 detail79 viewsrabbet plane ( rebate Jeff ) awaiting 1st assignmentSchwartz
|
|
Cabinet_front.jpgCabinet front closed152 viewsThe carcase and frame is all made from a single 40 year old air dried Appalachian black walnut board. The two panels are resawn and book matched from a single off cut of Indiana black walnut saved from the burn pile. The finish is four coals of 1-pound cut amber shellac, well rubbed out with 0000 steel wood after each coat. The whole is finished with a coat of Liberon brown paste wax. The knob is an ebony violin tuning peg. Closure is achieved by a rare earth magnet and a steel screw.Sgt42RHR
|
|
cabinet_open_empty.jpgCabinet open and empty132 viewsThis is the inside showing the poplar back and the reverse of the book matched front panels. The hangers are 1 1/2 inch Tremont cut finishing nails set in pre-drilled holes with a dab of CA glue.Sgt42RHR
|
|
Cabinet_open_full.jpgcabinet open full155 viewsHere are some of the reasons I built this cabinet which is attached to wall studs just over and to the side of the dresser.
Sgt42RHR
|
|
cabinet_oblique_view.jpgOblique view110 viewsThe cabinet is about 4 inches deep, with each side having about 1 3/4 inches depth on the inside. The knob is an ebony violin tuning peg.Sgt42RHR
|
|
GC_2017.jpgGalootaclaus 201713 viewsfrom Doc Holladaydlarue
|
|
Galootaclaus_2017.jpgGalootaclaus 201764 viewsSuch a thoughtful and bountiful gift box! Galootaclaus rocks!Sgt42RHR
|
|
gc2017.jpgGC 2017 Gifts52 viewsA hearty "thank you" to my gifter, Stuart Minuskin. Inside the flat rate box was a Chris Vesper chip-carving knife, a new headlamp, a pocket Stanley Tool reference book, a nicely turned pen, a calendar from Queensland for the shop, and a "The Tool Exchange" t-shirt. Merry Christmas, Stuart!madwing
|
|
Galootaclaus2017-2.jpgHardwood billets from Galootaclaus59 viewssaltchuck
|
|
| 4802 files on 401 page(s) |
 |
1 | |
|
|
|
|
|
|
|
|
|
|
|
Image Central 
