| Most viewed - Making a Box for Steven |
Starting_the_cut_with_a_back_saw.JPGStarting the cut with a back saw198 viewsI cut in a couple of inches at each corner with my Adria tenon saw. I then used the frame saw to cut about halfway, then turn and do the other side, then repeat on the other end. The frame saw tracked well and was generally easy to control.Sgt42RHR
|
|
Ready_to_build_a_box_for_Steven.JPGReady to build a box for Steven177 viewsI used the frame saw I made to cut a 7/8" thick scrap walnut board into two boards that were each 5/16" thick, roughly 5" x 11"Sgt42RHR
|
|
Using_a_frame_saw_to_multiply_by_dividing.JPGUsing a frame saw to multiply by dividing166 viewsThe frame saw I built with walnut scraps from the folding bed project worked great! I gaged a pretty deep line around each board and sawed to the line. I was able to get 5/16" thick stuff after I planed the saw marks away.Sgt42RHR
|
|
Walnut_sliding_top_box_to_hold_shotgun_shells.JPGWalnut sliding top box to hold shotgun shells165 viewsSgt42RHR
|
|
42d_RHR_button_and_King_s_Storekeeper_mark_for_1st_Model_Brown_Bess.JPG42d RHR button & King's Storekeeper mark for 1st Model Brown Bess145 viewsSgt42RHR
|
|
Beveled_floating_bottom.JPGBeveled floating bottom130 viewsSgt42RHR
|
|
|
|
|
|
Image Central 
