| Search results - "brass" |
GC2016.JPGGaloot a Claus 201640 viewsBooks on iron and scrollsaw work, shopmade brass square/sanding blocks, caliper rule, Stanley chisel, LV calendar, Swiss chocolate plane and gnome (don't ask) and fine adult libationsnicknaylo
|
|
Massachusetts_low_chest_drawer_pull_hardware.jpgDrawer pulls87 viewsAll hardware was bright brass from Ball & Ball. I painted it all with gun bluing which turned it black, then I steel wooled and polished with Simichrome polish which left patina in the deep recesses and hard to reach spots. In this view, one can also see the effect of the dark glaze applied in the fillet of the thumbnail moulding around the drawers.Sgt42RHR
|
|
pencils.jpgbig old round pencils23 viewsWolverine Brass
Company Limited
Manufacturers and distributors of
Guaranteed Plumbing and Heating Specialties
Tools and Brass Goods
Toronto - Canadadlarue
|
|
20140815_1728ss.jpgnew ferrule coing up!132 viewsgouge and brass fitting mounted to Handy collett chuck, shaped dowel in existing tang holeSchwartz
|
|
20140815_1734ss.jpgW. Butcher converted for turning150 viewsnew ferrule turned from a brass 1in x 3/4in plumbing adapterSchwartz
|
|
bagpipe_case_front_hardware.jpgCase Hardware85 viewsLeather handle dyed cordovan and affixed with brass keepers and polished steel screws. Brass latches, one locks. Trunk hinges on the rear edge hold the lid open at 95 degrees.Sgt42RHR
|
|
folding_table_showing_webbing_hinges_and_catch_hardware~0.jpgFolding table showing webbing, hinges, and catch hardware104 viewsThe webbing limits the outward travel of the legs and at the same time provides tension against the brass catches that anchor the moveable end of the table top to the legs.Sgt42RHR
|
|
folding_table_underside_of_top_folding.jpgUnderside of folding table top95 viewsIn preparation for folding, this shows the underside of the table top. The two brass latches that secure the top are visible at the bottom.Sgt42RHR
|
|
Goose_neck_knife_hinges_on_folding_table.jpgGoose Neck Knife Hinges84 viewsI made these hinges using 1/8" thick brass. The goose neck design is necessary in order to allow the table top to fold around and lay flat against the back of the legs for storage or transportation.Sgt42RHR
|
|
folding_table_unfolded_and_ready_for_use.jpgGeorge III Folding table131 viewsThis mahogany table is 16" x 30" x 30" tall and is made from mahogany, webbing, and brass.Sgt42RHR
|
|
notscrews.jpgWhatsits59 viewsBrass, steel, potmetal, I can't tell what. Look like, for the most part, screws that have no threads/slot, or cotter pins with no holes.madwing
|
|
flea_finds_5.jpgParallel rule 84 viewsEbony and Brass....I don't see a lot of nautical memorabilia in Oklahoma...passed on it some time ago and regreted it...showed up again today so I snagged it for $15 roy griggs
|
|
| 114 files on 10 page(s) |
 |
1 | |
|
|
|
|
|
|
|
|
|
Image Central 
