| Search results - "knob" |
Cabinet_front.jpgCabinet front closed152 viewsThe carcase and frame is all made from a single 40 year old air dried Appalachian black walnut board. The two panels are resawn and book matched from a single off cut of Indiana black walnut saved from the burn pile. The finish is four coals of 1-pound cut amber shellac, well rubbed out with 0000 steel wood after each coat. The whole is finished with a coat of Liberon brown paste wax. The knob is an ebony violin tuning peg. Closure is achieved by a rare earth magnet and a steel screw.Sgt42RHR
|
|
cabinet_oblique_view.jpgOblique view110 viewsThe cabinet is about 4 inches deep, with each side having about 1 3/4 inches depth on the inside. The knob is an ebony violin tuning peg.Sgt42RHR
|
|
IMG_20170402_101624.jpgdont buy that30 viewsa stanley 45 plow plane for a good price, despite the missing knob and only the one cutter.
I resisted the urge to buy it as I already have a couple of these. dlarue
|
|
hot_handles.jpghot handles78 viewscloset door knobsdlarue
|
|
IMG_4075.jpgFront knob installed, prior to tote and lever cap99 viewsjerkinsj
|
|
SugarBowl.jpgGalootaclaus Reloaded23 viewsNew knob on the sugar bowl lid, made from some walnut I got from a previous year's Galootaclaus Gift.dlarue
|
|
6_c_knob.jpgKnob84 viewsUnder the grime, I found this beautiful rosewood. no cracks or chips. Brentpmed
|
|
K2-C6.JPGK2C TOE AND KNOB37 viewsJAPANNING LOSS AT THE "K" AND "2" THERE IS A TIGHT CHECK IN THE KNOB. Brentpmed
|
|
detail_of_lock_and_joints.JPGDetail of box joints and lock199 viewsThe joints forming the corners of this box are quite fine. Note also the tiny turned knobs on the compartments, and the thin dividers between the spaces for the razorsSgt42RHR
|
|
2012_8525s.jpgDetail of MF 1285C All Steel mitre box132 viewsWanted: 2 Knurled nuts or knobs to fit threaded portion of spring-loaded elevator release pulls on both posts. One is in foreground directly above the red MF tag, the other in the background, just above the fence line.Schwartz
|
|
knob_blank_1.jpgKnob Blank135 views I cut the knob blank 2"X2"X2". The top and bottom must be very parallel. and the height is the finished height of the knob. On the top drill a 7/16" diameter hole 1/2" deep for the brass mounting nut. On the bottom drill a 19/32" diameter hole 1/2" deep to fit over the boss on the plane. Then drill a 5/16" hole through. Turning is the last thing I do. writt
|
|
knob_blank_2.jpgKnob Blank Bottom114 views This is the bottom of the knob blank. You can see the 19/23" diameter hole and the 5/16" diameter thru hole. writt
|
|
|
|
Image Central 
