|
|
|
Boring 1
|
|
Boring all four holes at the correct angle is the only real challenging part of the project, and I used a Stanley #18 bevel clamped to the work, along with some guide lines to keep the angles consistent. Since the large auger I wanted to use lacked forward facing spurs, I started each hole with a #20 spur bit in a brace, then switched to the big 1 1/4" two-handed auger as soon as I had scored the entry cut enough to avoid tear-out.
|
|
 |
|
IMG_0201.JPG
|
IMG_0155.JPG
|
IMG_0157.JPG
|
IMG_0118.JPG
|
ID_this_wood_1.jpg
|
|
|
|
Image Central 
