Making a Frame Saw |
 |
| TITLE |
+ |
- |
| FILE NAME |
+ |
- |
| DATE |
+ |
- |
| POSITION |
+ |
- |
|
|
The_results_of_my_round_mortise_and_tenon_efforts.JPGThe results of my round mortise and tenon efforts104 viewsI think two problems contributed to this failure: the round tenons were not completely at right angles, and the drilled mortises were not at right angles. It was fun using the hollow auger nonetheless!Sgt42RHR
|
|
The_fix--Bridle_joints.JPGCutting bridle joints out of the failed round mortises86 viewsSgt42RHR
|
|
Stanley_No__65_Chamfer_Shave_worked_like_a_charm.JPGStanley No. 65 chamfer shave worked great!91 viewsSgt42RHR
|
|
Slenderized_Framesaw.JPGSlenderized Frame Saw201 viewsI went from 6.5 pounds to 3.5 pounds. The side arms are now only 7/8" thick and the far end stretcher is 1 1/8 with a reinforcer where the 1/2" bolt hole and redundant 1/4" grove for the saw blade are. I rechamfered all the newly cut edges with 1/2" wide chamfers to further lighten the tool and to make it easy to grasp.Sgt42RHR
|
|
Roughing_oak_dowel_pins_from_a_bit_of_firewood.JPGRoughing oak dowel pins from a bit of firewood81 viewsSgt42RHR
|
|
Ready_to_drill_the_round_mortise.JPGReady to drill the round mortises84 viewsSgt42RHR
|
|
Preparing_to_make_the_round_tenon.JPGPreparing to make the round tenons83 viewsSgt42RHR
|
|
Making_oak_dowel_pins_with_refurbished_dowel_plate.JPGMaking oak dowel pins with a refurbished dowel plate84 viewsSgt42RHR
|
|
Finished_with_a_little_mineral_spirits_to_see_what_it_will_look_like.JPGAll done, with a little mineral spirits to see what it will look like with a top coat107 viewsSgt42RHR
|
|
effort_on_4_inch_white_pine.JPGThird effort, this time on 4 inch wide white pine98 viewsSgt42RHR
|
|
Cutting_the_round_tenon_with_hollow_auger.JPGCutting the round tenons with a hollow auger103 viewsSgt42RHR
|
|
Bridle_joints_worked_just_fine.JPGBridle joints were an excellent solution98 viewsSgt42RHR
|
|
| 14 files on 2 page(s) |
|
1 | |
|
Image Central 
