|
|
|
Vise problem 1
|
|
This shot taken while fitting the screws to the face vise shows the basic configuration of the face vise itself and the two backing slabs which are bolted top to bottom through the benchtop. Each backing slab has two 3/8 inch bolts running through them. Nevertheless, I still found that if I clamped a board in the face vise, and it only bore against the top and the face vise, or the leg and the face vise, but not the backing slabs, I could easily put enough force on it to pull the slabs out of alignment.
|
|
 |
|
IMG_1045.JPG
|
IMG_1051.JPG
|
IMG_1027.JPG
|
IMG_1061.JPG
|
IMG_1062.JPG
|
|
|
|
Image Central 
