Shop Pix |
 |
| TITLE |
+ |
- |
| FILE NAME |
+ |
- |
| DATE |
+ |
- |
| POSITION |
+ |
- |
|
|
Simonds_Medallion.JPGsimonds medallion44 viewsmedallion on small Simonds sawdlarue
|
|
100_1280.JPGNew & Improved Wood Rack75 viewsNow I can store my seldom-used utility trailer under the wood rack. I can almost park a CAR in the garage now!dlarue
|
|
Simonds_Saw.JPGSimonds Saw44 viewssmall Simonds sawdlarue
|
|
molding_profile.JPGFinished profile55 viewsThis is the finished profile. The hardest part is always the transition on the ogee from hollow to round. I usually end up just saying "OK good enough" and give up on it. All that needs to be done now is to bevel off the corners so it will sit properly where it is supposed to go...dlarue
|
|
100_1296.JPGName stamp on quilt rack52 viewsI stamped the end of the lower stretcher tenon with my Mazzaglia Tools name stamp.dlarue
|
|
100_1297.JPGfinished quilt rack56 viewshere's the quilt rack, with Kathy's partially completed quilt hanging off'n it.dlarue
|
|
100_1293.JPGquilt rack85 viewswhite pine with cherry wedges. dlarue
|
|
molding_plowed.JPGMolding Plowed51 viewsThe main concave parts have been sunk with a plow plane. This gives the round planes somewhere to register. The planes have no fences or depth stops.dlarue
|
|
molding_planes.JPGMolding Planes63 viewsHollows & rounds and a skew rebate plane.
This is all you need to make this molding.
Actually, I also used a block plane and a shoulder plane. My bad.dlarue
|
|
molding_layout.JPGMolding Layout43 viewsHere's the layout of the molding I want to make. This is just a rough guide. If things go well, it will look like I followed this layout. Otherwise, I just get what I get.dlarue
|
|
molding_done.JPGMolding Done47 viewsHere's the finished molding. I knocked the corners off with a drawknife and planed down to my layout with a Stanley #4 smoother.
The molding is propped up at the angle it will be installed at, with some oblique lighting to highlight the shape.dlarue
|
|
molding_cove2.JPGMolding, two coves45 viewsBoth coves are done now. Next the convex part needs to be molded.dlarue
|
|
| 311 files on 26 page(s) |
|
|
|
|
|
5 | |
|
|
|
|
|
|
|
Image Central 
